Page 22
Stratos HSSD-2 • INSTALLER’S HANDBOOK • Iss. 12
3.4.38 Call centre (Numeric - CM only)
Setup menu > Pager
This is the phone number the modem dials up to send a message. For further details on
this and the other functions in the “Pager” submenu, see section 6.1.3, “Paging from
the Command Module”.
3.4.39 Password (Alpha - CM only)
Setup menu > Pager
This is an optional password used to access the system.
3.4.40 Pager (Numeric - CM only)
Setup menu > Pager
This is the number of the actual pager.
3.4.41 Page on fault (Yes/No - CM only)
Setup menu > Pager
Where a pager has been allocated as above, this function determines whether the pager
holder is to be paged when a fault condition is generated by the Command Module.
3.4.42 Page on alarm (Yes/No - CM only)
Setup menu > Pager
Where a pager has been allocated as above, this function determines whether the
pager holder is to be paged when a fire alarm condition is generated by the Command
Module.
3.4.43 View event log (Display - Address 000-127)
Log menu
This function shows the start and stop time and date of events such as FastLearn, alarm
condition and error messages. The event log can also be downloaded to a PC via the
RS232 serial port.
See section 7, “Event log” and section 8.5, “Connecting to a PC” for further details.
3.4.44 Diagnostics (Test - Address 001-127)
Diagnostic menu
This function puts the detector into self-test mode. On a Command Module, it tests all
detectors on the loop.
To Next Page
Loading...
