Page 12
Stratos HSSD-2 • INSTALLER’S HANDBOOK • Iss. 12
3.3 Navigating through
the menus
To navigate through the main menu options, press to navigate through the
available choices. The display shows two adjacent items, e.g.
i.e., selects items lower in the list by effectively scrolling the screen UP, and vice
versa for
.
The currently selected item is the upper item of the two and is identified by a trailing
arrow as shown (for a menu) or a trailing dot (for a menu item or single choice such as
Exit). When you have the menu you require, press
. This then gives you a choice
of the items within the selected menu, e.g. as follows to set the main fire alarm level.
or pressing
would show:
Pressing
would then show:
Setup menu ➞
Log menu
Setup menu
Log menu
Exit
Setup menu
Log menu
Diagnostic menu
Time and date •
Alarm levels
Alarm levels •
Alarm actions
Fire 2 level
(1-25) : 20
Fire 1 level
(8-10) : 08
Fire 1 level
(8-10) : 08
Fire 1 level
(8-10) : 18
Fire 1 level
(8-10) : 18
Fire 1 level
(8-10) : 19
Fire 1 level
(8-10) : 10
Pre Alarm level
(3-8) : 04
Having entered the Fire 1 level, the selected item indicator steps along to the item
below it in the Alarm levels submenu. Either this can be edited as above, or
can be used to move to the next choice. Once the last entry in the sub-menus reached
pressing
will move you back up to the Setup menu. Pressing <RESET> at any time
exits programming mode, assuming the <RESET> button is enabled.
Section 3.5 shows the full menu map for the Stratos-HSSD-2, showing the choices
available within each menu and submenu.
Move the menu pointer progres-
sively towards the left or right of the map as appropriate, and
step up/down
the choices in the currently selected menu or submenu. Items within sub-menus are
sequentially accessed with the
button followed by the button. Values are edited
with
followed by .
To Next Page
Loading...
