Page 38
Stratos HSSD-2 • INSTALLER’S HANDBOOK • Iss. 12
6.1.4 Configuring the software
No manual configuration of the modem is required as the command module config-
ures the modem automatically on dialling.
The command module has three entries used to send messages. They are described
below with an example for a BT pager. The functions may be found in Setup menu
➔ Pager.
Call centre
This is the phone number the modem dials up to send a message. For the BT EasyReach
service this number is 09011130000.
Password
This is an optional password used to access the system. BT EasyReach does not use the
password so leave this entry blank.
Pager
This is the number of the actual pager. This number will be detailed in the pager or
SMS phone documentation.
An event is defined as operation of any of the front panel controls (when enabled), a
signal received from a remote source (e.g. the Command Module or PC), a detector
level exceeding the Aux., Pre-Alarm, Fire 1 or Fire 2 thresholds or certain commands
sent from the remote software or SenseNET. The event log will also store items such
as day and night start times, demonstration mode, power fault, detector fault etc. The
detector keeps a log of the last 200 events for reference purposes.
The event log can be downloaded using a PC that has the remote software installed
and is connected to the Stratos HSSD 2‘s RS 232 port using a serial cable. See section
8.5, ‘Connecting to a PC‘.
The event log can also be viewed in the Log menu , which prints out the event log in
reverse order i.e. the last recorded event is printed out first.
When the buffer that stores events is full (200 events are stored) and a new event
occurs, the oldest event in the buffer is discarded.
7. Event log
To Next Page
Loading...
