Page 3
Stratos HSSD-2 • INSTALLER’S HANDBOOK • Iss. 12
Stratos-HSSD-2
®
is a highly sophisticated ‘next generation‘ of High Sensitivity
Aspirating Smoke Detection product that has been designed to ensure that installation
and commissioning is as simple as possible, while optimising performance.
Stratos incorporates a patented ‘artificial intelligence‘ known as ClassiFire
®
, which
allows the detector to configure itself to optimum sensitivity, alarm thresholds and
minimum nuisance alarms for any environment.
ClassiFire intelligence also monitors the detector chamber and dust separator
for contamination, continually adjusting the appropriate operating parameters to
counteract the negative effects of such contamination.
Stratos is unique in being able to provide a consistent level of protection in a very wide
range of environments by continuously making minor adjustments to sensitivity.
Stratos has proven its worth many times by detecting ‘difficult-to-detect‘ slow growth
electrical overload incipient fires in ‘difficult‘ environments.
This handbook gives information likely to be needed for most installations, but for
more detailed information on subjects such as
Fresh Air Referencing, please refer to the
complete Technical Manual or System Design Guide.
This equipment is Class 111 as defined in EN60950 (i.e., this equipment is designed to
operate from Safety Extra Low Voltages and does not generate any hazardous voltages).
This label is located on the laser chamber at the bottom right of the open detector and
signifies that the unit is a Class 1 Laser product as specified in IEC 60825-1. The unit
incorporates a Class 3B embedded laser which must not be removed from the detector
as retinal damage may result if the laser beam enters the eye.
As this equipment is part of a fire detection system, it should be supplied from an
approved power supply conforming to EN54-4.
This symbol appears on the main board of the unit and indicates that the board
contains static sensitive components. Suitable anti-static precautions must be taken
when handling the board, eg. for fuse replacement.
This symbol indicates the Safety Earth studs (see sections 1.3 and 1.4). These are for
grounding cable screens etc. and should not be connected to 0V or signal earth.
Kidde Products Ltd. has taken every care to ensure that Stratos is as simple to install
as possible but in case of difficulty, please contact our Help Line to ensure trouble free
installation and operation.
Kidde Products Ltd. takes no responsibility for damage or injury occasioned as a result
of failing to install or operate the equipment in accordance with these instructions.
Throughout this manual, where an entry is shown as Example, this is intended as
a representation of the text appearing on the LCD screen on the detector (if fitted)
when the option is selected, eg Setup menu.
Entries shown as <EXAMPLE> represent function buttons on the front of the
detector, eg. <TEST>.
Introduction
HELP LINE
(+44) (0) 1844 265004
LASER CLASS 1
PRODUCT
0832
Kidde Products Limited
Unit 2 Blair Way Dawdon
City: Seaham, County Durham
SR7 7PP, UK
09
0832-CPD-1076
0832-CPD-1077
0832-CPD-1078
EN54-20: 2006
Aspirating smoke detectors
for fire detection and fire alarm
systems for buildings
Class A, B
and C
Technical data: see INF48022 and
INF48023 held by the manufacturer
To Next Page
Loading...
