Kidde VS4 User Manual

Chapter 2: Front panel programming
120 P/N 3102351-EN • REV 005 • ISS 28DEC18
Printer: Yes or No. This controls whether event information is sent to the printer
Dialer:
• Acct 1 & 2: Event information is sent to both dialer accounts
• Acct 1: Event information is sent to dialer account one
• Acct 2: Event information is sent to dialer account two
• None: Event information is not sent to the dialer
CID: Contact ID event code (000 to 999)
Network: Controls whether event information is sent to the connected network
8. When you have finished configuring each page, choose Save.
9. Repeat steps 6 to 9 for each panel event.
10. Press the Menu button to exit menu mode, or continue programming.
Loop event programming
Loop events, such as loop fault, map fault, and loop initialization have an event notification
setting for contact ID, dialer, NET (1-8), and printer, which controls where the event is sent
when it takes place. Each event has a factory default setting that can be used with no
additional programming.
Table 37: Default loop event settings
Loop event
Printer
Dialer
NET (1-8) CID
Loop 1
initialization Yes
None
No n/a
Loop 1 fault (disable)
Yes
None
No n/a
Loop 1 fault (trouble)
Yes
Acct 1
No 331
Loop 1 map fault
Yes
Acct 1
NoNo 331
Loop 1 card fault (disable) (
e.g., line fault) Yes
None
No n/a
Loop 1 card fault (trouble) (
e.g., line fault) Yes
Acct 1
No 333
Loop 1 Uncfgrd alarm (disable)
Yes
None
No n/a
Loop 1 Uncfgrd alarm (trouble)
Yes
Acct 1
No 110
Loop 1 Uncfgrd trbl (disable)
Yes
None
No n/a
Loop 1 Uncfgrd trbl (trouble)
No
None
No n/a
Loop 1 map mismatch
Yes
None
No n/a
Loop 1 over limits
Yes
None
No n/a
Loop 1 mapping
Yes
None
No n/a
Loop 2 initialization
Yes
None
No 000
Loop 2 fault (disable)
Yes
None
No 500

Kidde VS4 Specifications

General

Brand	Kidde
Model	VS4
Category	Fire Alarms
Language	English