Chapter 2: Front panel programming
86 P/N 3102351-EN • REV 005 • ISS 28DEC18
To copy the members of a correlation group:
1. Press the Menu button and choose Programming.
2. Choose Advanced Program and enter the level 2 password.
3 Choose Loop Configuration.
4. Choose Correlation Groups.
5. Enter the number of the correlation group to be programmed. (Values range from 001 to
199.)
6. Choose Copy and enter the number of the correlation group to be copied.
7. Choose Save.
To remove all members from a correlation group:
1. Press the Menu button and choose Programming.
2. Choose Advanced Program and enter the level 2 password.
3 Choose Loop Configuration.
4. Choose Correlation Groups.
5. Enter the number of the correlation group. (Values range from 001 to 199.)
6. Choose Remove All. A warning message is displayed.
7. Choose Continue to remove all members from the group.
— or —
Press the Cancel button to return to the previous level without removing all members.
Note: Removing all members from a correlation group resets the activation count to 1 and
disables in-suite signal silence.
Adding delay time to correlation groups
Using the Delay option, you can program your panel to delay the execution of a correlation
group n seconds. A delay is required so that the prerelease and release responses occur in
the correct order. Prerelease correlations must occur before release correlations.
To Next Page
Loading...
Need help?
General
