Kimo 210-R Series - Page 17

• 0/3: relay is deactivated
• 1/3: rising edge mode
• 2/3: falling edge mode
• 3/3: monitoring mode
➢ Press OK.
“F 400” blinks.
➢ Press Up key to go to the “F 401” folder of relay 1 (“F 411” for relay 2) then press OK.
➢ With Up and Down keys, select the channel where the relay will be activated.
➢ Press OK.
“F 401” blinks.
➢ Press Up key to go to the “F 402” folder (“F 412” for relay 2) then press OK.
This folder corresponds to the threshold 1 settings.
➢ Set the threshold 1 with the Up and Down keys.
➢ Press OK when the last digit has been set.
“F 402” blinks.
➢ Press Up key to go to the “F 403” folder (“F 413” for relay 2) then press OK.
This folder concerns:
• For a rising or falling edge: hysteresis setting
• For a monitoring: threshold 2 setting
➢ Set the hysteresis or threshold 2 with the Up and Down keys.
➢ Press OK when the last digit has been set.
“F 403” blinks.
➢ Press Up key to go to the “F 404” folder (“F 414” for relay 2) then press OK.
This folder corresponds to the delay 1 setting.
➢ Set the delay 1 with the Up and Down keys.
➢ Press OK when the last digit has been set.
“F 404” blinks.
➢ Press the Up key to go to the “F 405” folder (“F 415” for relay 2) then press OK.
This folder corresponds to the delay 2 setting.
➢ Set the delay 2 with Up and Down keys.
➢ Press OK when the last digit has been set.
“F 405” blinks.
➢ Press Up key to go to the “F 406” folder (“F 416” for relay 2) then press OK.
This folder corresponds to the relay safety. The relay outputs are by default, in negative security: the relay is
energized when a set point is reached. With the keypad, you can swap the relays in positive security: then, the
relay is de-energised when a set point is reached or during a power outage.
➢ Activate or deactivate the safety relay with Up and Down keys.
• 1: positive safety
• 0: negative safety
➢ Press OK to confirm.
F 400: MANAGE THE RELAYS 17