3. ACCESS TO THE DIFFERENT FUNCTIONS
This step is compulsory for each configuration.
First, to access to the transmitter functions, and for safety, a safety code must be entered. This safety code is 0101 and can
not be modified.
The transmitter must be energised.
➢ Connect the transmitter.
➢ Wait for the initialisation phase.
➢ Press OK.
The screen displays “Code” with “0000”. The first 0 blinks.
➢ Press OK to go to the second 0.
It blinks.
➢ Press Up key to display 1 then press OK.
The third 0 blinks.
➢ Press OK to go to the fourth 0.
➢ Press Up key to display 1 then press OK.
The following screen is displayed:
“F 100” is for the number of the configuration folder. There are 6 folders:
• F 100: folder of the transmitter configuration. See page 9
• F 200: folder of the channels and units of measurement. See page 11
• F 300: folder of the analogue outputs. See page 12
• F 400: folder of the relays configuration. See page 16
• F 500: folder of the measurement configuration. See page 18
• F 600: folder of the measurement configuration specific to the COT212-R, CP210-R and CTV210-R transmitters.
See page 21
To select the required folder:
“F 100” is displayed and 1 is blinking.
➢ Press Up key until the number of the required folder is display (“F 100”, “F 200”, “F 300”, “F 400”, “F 500”
or “F 600” according to the type of transmitter).
➢ Press OK.
If a wrong code is entered, “CODE” blinks a few seconds on the bottom right of the screen then
the measured values are displayed. It is necessary to enter the right code.
8
ACCESS TO THE DIFFERENT FUNCTIONS
F 100
Code
0101
To Next Page
Loading...
Need help?
General
