Kimo 210-R Series User Manual

9. F 600: COMPENSATION, MEANS OF MEASUREMENT AND
SECTION SETTINGS
9.1. Temperature compensation (CP210-R)
It is possible to modify the temperature compensation. Indeed the air velocity and airflow measured with a differential
probe (such as Pitot tube, Debimo blade, orifice plate...) depends on the working temperature. Then, it is required to enter
the working temperature to get more accurate results.
9.1.1 Set the unit
The transmitter is powered on.
➢ Press OK.
➢ Enter the activation code (see page 8).
➢ Press OK.
➢ Press Up key to go to “F 600” folder.
➢ Press OK.
➢ Select 0 for °C or 1 for °F then press OK.
9.1.2 Set the temperature compensation value temperature
The transmitter is powered on.
➢ Press OK.
➢ Enter the activation code (see page 8).
➢ Press OK.
➢ Press Up key to go to “F 602” folder.
➢ Press OK.
The 1
st
digit blinks.
➢ Press Up or Down key to set the temperature sign: 0 for a positive temperature or – for a negative
temperature.
➢ Press OK.
The 2
nd
digit blinks.
➢ Press Up or Down key to set the digit then press OK.
➢ Repeat the procedure for the following digits.
➢ Press OK when the last digit has been set to validate the temperature compensation value.
9.2. Altitude compensation (COT212-R, CP210-R and CTV210-R)
If measurements are performed at a specific altitude, it is advised to set the altitude in which the transmitter is.
The transmitter is powered on.
➢ Press OK.
➢ Enter the activation code (see page 8).
➢ Press OK.
➢ Press Up key to go to “F 605” folder.
➢ Press OK.
The 1
st
digit blinks.
➢ Press Up or Down to set the digit: only 1 and 0 are available.
➢ Press OK.
The 2
nd
digit blinks.
➢ Press Up and Down key to set the digit then press OK.
➢ Repeat the procedure to set the following digits.
➢ Press OK when the last digit has been set to validate the altitude value.
F 600: COMPENSATION, MEANS OF MEASUREMENT AND SECTION SETTINGS 21

Kimo 210-R Series Specifications

General

Brand	Kimo
Model	210-R Series
Category	Transmitter
Language	English