➢ Press Up key then press OK to enter in the “F 531” folder corresponding to the offset of the second parameter.
The first number of the offset blinks.
➢ Enter with Up and Down keys the number value or the negative sign of the value then press OK.
The second number blinks
➢ Enter with Up and Down keys its value then press OK.
➢ Repeat the procedure for the following numbers.
➢ Press OK when the last number is set.
“F 531” blinks, the offset for the main parameter is configured.
The unit of the offset is set by default and can not be modified. If this unit is not the same than
the unit of measurement, a conversion must be done.
20
F 500: MEASUREMENT SETTINGS
To Next Page
Loading...
Need help?
General
