1 INTRODUCTION
KINEMATICA is a specialist for design and manufacturing of dispersing and mixing
machines. The aim of this document is to instruct new users in the effective and safe
utilization of our equipment.
The KINEMATICA Inline homogenizing system MEGATRON
®
MT 3100 S² has been
designed and manufactured according the EC guidelines, the actual technical
standards and applicable safety rules and is marked with the CE mark.
This document is valid for the KINEMATICA Inline homogenizing system
MEGATRON
®
MT 3100 S².
The system is designed and manufactured for the intended application consisting of:
• In-Line processing of flowable and pumpable products under the considera-
tions and limitations given in the “Technical Data”.
• The processed media must be compatible with all constructional parts wetted
by the product.
• If suitable precautions to personnel are taken to prevent any harm due to
noise emission.
• The use of the system with no structural, mechanical or electrical changes dif-
ferent from the original scope of supply.
Typical applications:
• Preparing emulsions
• Pharmaceutical or cosmetics products
• Suspending solids in liquids (such as liquid polymers)
• Dispersing fine solids in liquids or molten phases
• Suspending additives and solid polymers in mineral oils
• Extracting enzymes from biomass
• Extracting active ingredients and substances from plants, for example (when
used with REACTRON®)
• Grinding and shredding of solids and fibers in liquids or polymers
If the system is used for purposes different than or over and above the capabilities
specified herein, KINEMATICA does not guarantee proper function and assumes no
obligation or liability.
Should you have any questions which are not answered in this document, please
contact KINEMATICA.
Check on www.kinematica.ch for your closest contact address.
To Next Page
Loading...