5C - CONNECTION DRAWING
PROGRAMMING BUTTONS
SET
FOP1
GND
FCC1
GND
24V
PHO1
GND
STOP
START
V+
LAMP
GND
ANT
V-
V+
GND
24V
PHO1
GND
STOP
START
V+
LAMP
GND
ANT
RAD
START
DIP-SWITCHESTRIMMER
MOTOR
SECONDARY
TRANSFORMER (20V)
PRIMARY
TRANSFORMER
(230V)
COURTESY
LIGHT
(24V max 15W)
CONNECTION
TERMINALS
EXTERNAL POWER
CONNECTION
FUSE BOX
(230VAC)
Not in use
1. Terminals 2 COMMON
2. + PHOTOCELLS (24Vdc)
3. Safety devices in closing contact PHO1
4. Terminal 4 - 6 COMMON
5. STOP contact
6. START contact
7. + FLASHING LAMP (24Vdc max 15W)
8. FLASHING LAMP negative
9. ANTENNA sock
10. ANTENNA signal
Not in use
+
2 1 13 2 1
RX TX
NC NOC
-
CLOSING PHOTOCELL
CONNECTION
+ -
FORZAOBS
The programming procedure terminates automatically in any case 10 seconds after the last transmission.
6 - RADIOTRANSMITTERS PROGRAMMING PROCEDURE
6A - START CHANNEL PROGRAMMING PROCEDURE
Power on the control
unit and set Dip 4 to ON
and Dip 5 to OFF
The led are off
Press button
RAD
for 2 seconds
The red led RAD comes on
The red led RAD comes on
Make a transmission
pressing the desired
button on the transmitter
The red led RAD flashes
Press button RAD
again to exit
the procedure
The red led RAD goes off
Memorize all the
transmitters making a
transmission with the
desired button
Power on the control
unit and set Dip 4 to OFF
and Dip 5 to ON
The led are off
Press button
RAD
for 2 seconds
Make a transmission
pressing the desired
button on the transmitter
The red led RAD flashes
Press button RAD
again to exit
the procedure
The red led RAD goes off
Memorize all the
transmitters making a
transmission with the
desired button
ON
1 2 3 4 5
OFF
led RAD
RAD
2 s
led RAD
led RAD
led RAD
RAD
1 s
The programming procedure terminates automatically in any case 10 seconds after the last transmission.
6B - PROGRAMMING THE CHANNEL FOR ACTIVATING THE COURTESY LIGHT
OFF
1 2 3 4 5
ON
led RAD
RAD
2 s
led RAD
led RAD
led RAD
RAD
1 s
L N
“MEMO PROG” (For the symbols, see paragraph 18)
“MEMO PROG” (For the symbols, see paragraph 18)
To Next Page
Loading...
