King gates ELEVO - 17 CE Declaration of Conformity

26
EN
17. CE Declaration of conformity
CE Declaration of conformity and declaration of incorporation of “partly-completed machinery”
Note: the contents of this declaration correspond to that stated in the ofcial document led in the ofces of KING Gates S.r.l. and, in
particular, to the latest version thereof available prior to the printing of this manual.
The text herein has been re-edited for editorial purposes. The UE declaration of conformity complete document is available at the following
link: www.king-gates.com/download/.
Declaration code: ELEVO
Rev.: 0.
Language: EN
Manufacturer’s name: KING GATES S.r.l.
Address: Via Malignani, 42 - 33077 - Sacile (PN) Italy
Type: Electromechanical gearmotor with incorporated control unit
Model: ELEVO
Accessories: STYLO 2K, STYLO 4K, DigyPad, Myo C4, Novo TX,
Novo Digy remote controls
• Directive 2014/53/EU (RED)
- Health protection standards (art. 3(1)(a)): EN 62479:2010
- Electrical safety (art. 3(1)(a)): EN 60950-1:2006+A11:2009+A12:2011+A1:2010+A2:2013
- electromagnetic compatibility (art. 3(1)(b)): EN 301 489-1 V2.2.0:2017, EN 301 489-3 V2.1.1:2017
- Radio spectrum (art. 3(2)): EN 300 220-2 V3.1.1:2017
In addition, the product conforms with the following Directive on partly completed machinery (Annex II, part 1, section B):
• Directive 2006/42/EC of the European Parliament and of the Council of 17 May 2006 on machinery, and amending Directive 95/16/EC
(recast), in accordance with the following harmonised standards:
- It is hereby declared that the relevant technical documentation has been compiled in accordance with Annex Vll Part B of Directive
2006/42/CE and that the following essential requirements have been applied and fullled: 1.1.1- 1.1.2- 1.1.3- 1.2.1-1.2.6- 1.5.1-1.5.2-
1.5.5- 1.5.6- 1.5.7- 1.5.8- 1.5.10- 1.5.11
- The manufacturer undertakes to transmit, in response to a reasoned request by the national authorities, relevant information on the
partly completed machinery. This shall be without prejudice to the intellectual property rights of the manufacturer of the partly completed
machinery.
- Should the partly completed machinery be put into service in a European country with an ofcial language different to the one used in this
declaration, a translation into that language must be provided by the person bringing the machinery into the language area in question.
- The partly completed machinery must not be put into service until the nal machinery into which it is to be incorporated has been declared
in conformity with the provisions of Directive 2006/42/EC, where appropriate;
In addition, the product complies with the following standards:
EN 60335-1:2012+A11:2014
EN 62233:2008
EN 61000-6-2:2005
EN 61000-6-3:2007+A1:2011
Sacile, 12-04-2018
Giorgio Zanutto
(Managing Director)