King-Meter Digital II-LCD - Personalized Parameter Setting; Personalized Setting Password Input

15
Personalized Parameter Setting
Personalized parameter setting can match variety requirements in
use. Setting items are: Battery indicator setting, PAS level setting,
Over-current cut, PAS sensor setting, Speed sensor setting and
Throttle function setting(optional) and System setting. In total six
items. For the details, please see the Attached List 3.
Personalized Setting Password Input
Hold both UP and DOWN for more than 2 seconds to enter normal
setting, then hold both UP and DOWN again to enter into
personalized parameter setting interface.
On the screen shows “P 3”, this requests to input permission
password. UP and DOWN is to change the number, and MODE is
to select digit one by one, finally press MODE to confirm. In case
password correct, enter the Power-on password enable setting
interface, otherwise stays at the password interface. Hold MODE
to exit. The permission password is : 2962.
Press UP/DOWN to select, and press MODE to enter the
corresponding setting page.