Step 2: Secure the wiring: After connecting the hardwire kit's output cable to the
dash cam's power port, use the installation tool and zip ties to neatly secure the
wiring on the windshield edge and prevent any potential hazards or distractions
while driving.
Step 3: Locate the constant fuse slot: Locate and open the fuse box typically
positioned beneath the dashboard. Then, identify the constant fuse slot within the
box. To do this, turn off your car engine, then use the circuit tester to test various
fuse slots available. Remember that if the circuit tester lights up during testing, it
indicates that you have successfully located the correct constant fuse slot.
Hardwire Kit
Hardwire Kit
To Next Page
Loading...
