Kingtel KT52IP - Page 52

Emergency Call
Number
The phone will dial the emergency call number even if the keyboard
is locked. And multi numbers can be added by “,”, such as 911,999
Enable Password Dial
When a number is entered beginning with the password prefix, the
following N numbers after the password prefix will be displayed as
*. N is the value entered in the Password Length field.
For example: If the password prefix is 3 and the Password Length is
2, then dialing the number 34567 will display 3**67 on the phone.
Password Dial Prefix
Prefix for password dialing as described above.
Password Dial Length
Length for password dialing as described above.
Enable Call History
Allow phone to save missed call/dialed call/incoming call or not.
Enable Default Line
If enabled, you can assigned default SIP line for dialing out, not
SIP1.
Alllow IP Call
Allow IP direct call, or disable IP call for dialing.
Play Talking DTMF
Tone
Allow DTMF voice played during talking, or only send DTMF
without local play.
Ban Outgoing
If enabled, no outgoing calls can be made.
Enable Call Waiting
If enabled, notifies user of a second call during a call. Caller ID of
the new caller will be displayed. Press HOLD button to place
existing call on hold and answer new call. Press HOLD again to
return to first call.
Enable 3-way
Conference
If enabled, allows 3-way conference.
Accept Any Call
If enabled, the phone will accept a call even if the called number
does not belong to the phone.
Enable Call
Completion
This is similar to Auto Redial except that the phone detects the state
of the called number before making a new call attempt.
Enable Pre-Dial
If this feature is enabled, digits dialed on-hook will be transmitted
when the phone goes off-hook.
Enable Silent Mode
If enabled, the phone will not ring to indicate a new call. Instead,
the light below the key pad will blink to indicate a new call.
Hide DTMF
This feature sets how DTMF digits are displayed after a call is in
progress. For example, dialing a PIN code to access banking
information. There are 4 choices.
13. Disabled – All the digits will be shown on the LCD.
14. All – None of the digits will be shown on the LCD. The “*”
will be shown.
15. Delay – The last digit entered will be shown for a short time and
then replaced by “*.”
16. Last Show – The last digit entered will be shown. Previous
digits are replaced by “*.”
Enable Intercom Mute
If enabled, mutes incoming calls during an intercom call
Enable Intercom Barge
If enabled, the phone will auto-answer an intercom call during an
outside call. If an intercom call is established, a second intercom