6-18 DK651/751/801/901
C86O626A
(1) Battery
(A) High (B) Low
BATTERY
CAUTION
To avoid personal injury:
Never remove the vent caps
while the engine is running.
Keep electrolyte away from eyes,
hands and clothes. If you are spat-
tered with it, wash it away com-
pletely with water immediately
and get medical attention.
Wear eye protection and rubber
gloves when working around the
battery.
1. Stop the engine and remove the key.
2. Apply moderate thumb pressure to belt
between pulleys.
3. If tension is incorrect, loosen the al-
ternator mounting bolts and, using a
lever placed between the alternator
and the engine block, pull the alterna-
tor out until the deflection of the belts
falls within acceptable limits.
4. Replace fan belt if it is damaged.
Proper
fan belt
tension
(A)
A deflection of between
7 ~ 9 mm (0.28 ~ 0.34 in.)
when the belt is pressed
in the middle of the span.
CAUTION
To avoid personal injury:
Be sure to stop the engine be-
fore checking belt tension.
C86O625A
(1) Generator (2) Bolt
(A) Check the Belt Tension
ADJUSTING FAN BELT TENSION
To Next Page
Loading...
