5-16 DK6511/751/801/901
C86O520A
The lowering speed of the 3-point hitch
can be controlled by adjusting the 3-point
lowering speed knob.
(1) 3-point hitch lowering speed knob
(A) Lock (
) Fast ( ) Slow
3-POINT HITCH LOWERING SPEEDMIXED CONTROL
In the draft control mode; when draft
decreases, the implement automatically
lowers to increase draft. To avoid hav-
ing the implement lowered too far, set
the position control lever at the lowest
working depth desired. Move the draft
control lever to the point where the imple-
ment is at the desired depth. This pre-
vents the implement from going too deep
and causing loss of traction and ground
speed.
C86O519A
(1) Ground Surface (2) Soft Soil
(3) Implement Penetration Limit
This will control the pull of the 3-point
implement. As the load on the 3-point hitch
changes due to various soil conditions,
the draft control system automatically re-
sponds to these changes by either rais-
ing or lowering the implement slightly to
maintain a constant pull.
Place the position control lever in the low-
est position and set the implement pull
with the draft control lever.
CAUTION
To avoid personal injury:
Fast lowering speed may cause
damage or injury. Lowering speed
of implement should be adjusted
to two or more seconds.
To Next Page
Loading...
