OPERATION 5-3
1. Applying the parking brake.
Pull the parking brake lever while fully
depressing the brake pedals. (The left
and right pedals should already be
latched together for this procedure).
The “P” lamp in the instrument panel
will turn on when the key switch is
turned on; indicating that the parking
brake is ON.
C86O501A
(1) Parking Brake Lever
OPERATING THE ENGINE
WARNING
Carefully read and understand
the instructions in this entire
manual; especially the “Safe Op-
eration” chapter; as well as all
decals and nameplates attached
to the tractor.
Avoid starting the engine in an
enclosed space. It may cause
death. Always run the engine in a
well ventilated area.
Before starting the engine; apply
the parking brake, shift the main
shift lever to neutral and turn the
PTO switch to OFF.
To avoid serious injury, do not
start the engine unless properly
seated at the operator’s station.
STARTING THE ENGINE
DK651 DK751/801/901
PRE-OPERATION CHECK
It is a good practice to know the condition
of your tractor before you start it. You
should do routine check before each use.
CAUTION
To avoid personal injury:
Be sure to check and service the
tractor on a level surface with the
engine shut off and the parking
brake “ENGAGED”.
To Next Page
Loading...
