Kioti DK Series - Changing Front Axle Case Oil; Changing Transmission Fluid

MAINTENANCE 6-13
IMPORTANT
Do not operate the tractor imme-
diately after changing the trans-
mission fluid.
Run the engine at medium speed
for a few minutes to prevent
damage to the transmission.
(1) Drain Plug
1. To drain the used oil, remove the drain
plug at the bottom of the transmission
case and drain the oil completely into
the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new KIOTI TF65 fluid up to
the upper line of the gauge.
(See “LUBRICANTS” in Maintenance
Section)
4. After running the engine for a few
minutes, stop it and check the oil level
again; add oil to prescribed level.
Oil Capacity
60
(15.85 U.S.gal.)
To avoid personal injury:
Allow engine to cool down
sufficiently, oil can be not and can
burn.
CAUTION
CHANGING TRANSMISSION FLUID
1. To drain the used oil, remove the right
and left drain plugs and filling plug at
the front axle case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil level check plug.
4. Fill with the new oil up to the check
plug port. (See “LUBRCANTS” in Main-
tenance Section)
5. After filling reinstall the filling plug and
check plug.
(1) Drain Plug (3) Filling Plug
(2) Check Plug
CHANGING FRONT AXLE CASE OIL
C86O613A C86O615A
C86O614A
Oil capacity
4.5 (1.2 u.s.gal.)
Each 3.5 (0.9 u.s.gal.)
Front axle case support
Frontaxle case (LH,RH)
Model
(1) Oil Inlet (2) Gauge
(A) Oil Level is Acceptable Within This Range