DISCRIPTION OF OPERATING SYSTEM 4-7
OFF
ACC
ON
HEAT
START
C86O406A C86O407A
KEY SWITCH
(1) Key Switch (A) Start (B) Heat
(C) On (D) Acc (E) Off
TURN SIGNAL/ HEADLIGHT/HORN
SWITCH
(1) Turn Signal Light Switch
(2) Head light Switch (3) Horn
(A) Right (B) N (C) Left
Turning the headlight switch one click
clockwise illuminates the low beam head-
lights and taillights. Turning it one more
click illuminates the high beam headlights.
OFF
Key position to shut down all systems.
Position for key removal.
ACC
Key position for operating accessory
functions with engine off.
ON / HEAT
Key position for engine operation. Posi-
tion also used for preheat when starting
a cold engine.
ST
Key position for operating the starter
motor.
OFF
Headlight is turned OFF
Low beam headlight is turned ON
High beam headlight is turned ON
Turn signal lamp is turned ON.
As a safety feature, the engine will
not start unless the clutch pedal is
depressed.
NOTE
STARTING INSTRUCTIONS
Inserting the key and turning it one click
to the right energizes the electrical sys-
tem and lights up the engine oil pressure
lamp (RED). Electrical accessories can
be operated in this position.
Depress the clutch pedal to disengage
the clutch. Next, turning the key to the
next position activates the glow plugs
which preheat the combustion chamber
when the engine is cold. After the glow
plug lamp has turned red and the engine
has been preheated, turn the key switch
to the right again to activate the starter
which will start the engine. Release the
key switch and it will return to the ON
position. Glow plugs will turn off
automatically. The preheat step is not
necessary for a warm engine.
To Next Page
Loading...
