23
CANISTER CLEANER AND ATTACHMENTS
2
Put Tech Drive® power assist in neutral by pressing down
on the left “N” Neutral pedal.
3
Raise the Headlight Hood. Flip out the handle on the Belt
Lifter.
Use it to turn the Belt Lifter
counterclockwise
until
the red arrows line up.
4
Turn the Accessory Lock counterclockwise to release the
Power Nozzle. Lift the Power Nozzle away. Clean any lint,
hair or debris from the Motor Shaft.
Motor shaft may be hot. Allow to cool before touching
or removing lint, hair or debris.
Keep Motor Shaft free from lint, hair, and debris build up.
Failure to follow these warnings may result in damage to
the Attachment Hose as well as bodily injury.
5
Place the hooks of the Attachment Hose over the Attaching
Bar. Push the opening of the Attachment Hose up against
the unit. Turn the Accessory Lock clockwise to lock in place.
Lower the Headlight Hood. Turn unit on.
The Upright Handle or the Portable Handle may be used
with the Attachment Hose.
If the unit will not turn on after connecting the Attachment
Hose, see page 58.
To Next Page
Loading...
Need help?
General
