Why is there no sound when the red LED (Tx) lights up on my Kirisun Transceiver?
If your Kirisun Transceiver is not transmitting sound even though the red LED (Tx) is lit, the issue might be a broken power module (resulting in no power output) or a broken microphone. Try replacing the power module or the microphone to resolve the problem.
What to do if my Kirisun Transceiver has no Rx signals?
If your Kirisun Transceiver isn't receiving any signals, it could be due to a few reasons. First, ensure the antenna is securely fastened. If that doesn't work, the HF amplifying tube might be broken and need replacement. Also, check your squelch level; if it's too high, reset it to allow signals to come through.
What to do if the green LED (Rx) lights up, but no sound is heard on my Kirisun Transceiver?
If you cannot hear anything when the green LED (Rx) is lit on your Kirisun Transceiver, the speaker or the audio amplifier might be broken. Please replace the speaker or the audio amplifier.
How to fix power on failure on a Kirisun Transceiver?
If you're experiencing power on failure with your Kirisun Transceiver, there are several potential causes. First, ensure the battery is properly reinstalled and reliably connected. If that's not the issue, the protective tube of the power supply, the power switch, or the CPU might be burnt out or broken and need replacement. Also, check if the battery is out of power and needs recharging or replacement.
Why is my Kirisun Transceiver beeping (phase lock loop unlocked)?
If you're experiencing a phase lock loop unlocked error (beeping) on your Kirisun Transceiver, it could be due to several reasons. The channel frequency setting might be out of range, so try resetting the channel data. Alternatively, the crystal oscillator, oscillating tube, or the phase lock loop IC could be broken and require replacement.
What to do if there is no talkback on my Kirisun Transceiver?
If you have no talkback on your Kirisun Transceiver, ensure that both radios are set to the same frequency. If they are not, select a channel with the matching frequency. Also, verify that the CTCSS/DCS signals are the same on both radios; if not, reset them. Consider that the radio might be out of effective communication range.
General| IP Rating | IP54 |
|---|---|
| Frequency Range | 400-470 MHz |
| Channel Spacing | 25KHz/12.5KHz |
| Power Output | 5 W |
| Operating Voltage | 7.4 V |
| Battery | 2000mAh (Li-Ion) |
To Next Page
