KIRLOSKAR CHILLERS PRIVATE LIMITED
A Kirloskar Group Company IOM-KAC-ENG - Page 32
WARNING:
The warranty becomes void if the wiring is not in accordance with Kirloskar Chillers
specifications.
The warranty is void if the settings on any of the protection devices are altered.
A blown fuse or tripped protector indicates a short ground or overload. Before replacing the
fuse or restarting the compressor, the cause must be found and corrected. Unqualified tampering
with the controls can cause serious damage to equipment and void the warranty.
4.2. System Service
4.2.1. Condenser and Evaporator
4.2.1.1. Air-Cooled Condensers
The KAC units are mounted with air-cooled condensers. Generally, no maintenance is required
except the occasional removal of dirt and debris from the outside surface of the fins. We
recommend the use of foaming coil cleaners available at air conditioning supply outlets. Care
should be taken not to damage the fins during cleaning.
Inspect the contacts of the motor
starters and controls.
Maintain history of service and any type of work done, including refrigerant charging, filter
drier changing, strainer cleanup / changing, compressor overhaul, electrical component failure
replacement etc.
Maintain log of the unit.
Maintain the history unit wise, in every unit item wise.
In case of any failure, these details will enable us to approach the problem in correct path.
NOTE: THE FREQUENCY OF INSPECTIONS MAY VARY WITH
TYPE OF APPLICATION OF THE PACKAGE.