KIRLOSKAR CHILLERS PRIVATE LIMITED
A Kirloskar Group Company IOM-KAC-ENG - Page 4
Electrical
DO NOT WORK ON HIGH-VOLTAGE equipment unless you are a qualified
electrician.
DO NOT WORK ON electrical components, including controls panels, switches, starters
OR oil heater until you are sure ALL POWER IS OFF and NO RESIDUAL VOLTAGE
can leak from capacitors OR solid state components.
LOCK OPEN & TAG electrical circuits during servicing. IF WORK IS INTERRUPTED,
confirm that all circuits are de-energized before resuming work.
Sharp Edges
The fins on the air-cooled condenser coils have sharp metal edges. Reasonable care should be
taken when working in contact with the coils to avoid the risk of minor abrasions and lacerations.
The use of gloves is recommended. Frame rails, brakes, and other components may also have
sharp edges. Reasonable care should be taken when working in contact with any components to
avoid risk of minor abrasions and lacerations.
Mechanical Strength
The unit is not designed to withstand loads or stresses from adjacent equipment, pipework or
structures. Additional components must not be mounted on the unit. Any such extraneous loads
may cause structural failure and may result in injury to the operator, or damage to the equipment.
Suitability for Application
The unit is intended for cooling water and is not suitable for purposes other than those specified
in these instructions. Any use of the equipment other than its intended use, or operation of the
equipment contrary to the relevant procedures may result in injury to the operator, or damage to
the equipment. The unit must not be operated outside the design parameters specified in this
manual.
To Next Page
Loading...