Klark Teknik square one dynamics - Installation and Electrical Safety

Safety precautions
4 Square ONE Dynamics
Installation
Before installing the equipment:
• Make sure the equipment is correctly connected to the protective earth conductor of the mains voltage
supply of the system installation through the mains lead.
• Power to the equipment must be via a fused spur.
• The power plug must be inserted in a socket outlet provided with a protective earth contact. The
electrical supply at the socket outlet must provide appropriate over-current protection.
• Both the mains supply and the quality of earthing must be adequate for the equipment.
• Before connecting up the equipment, check that the mains power supply voltage rating corresponds with
the local mains power supply and that the mains fuse is of the correct type and rating.
Location
• Ideally a cool area is preferred not in close proximity to power distribution equipment or other potential
sources of interference.
• Do not install the equipment in places of poor ventilation.
• Do not install this equipment in a location subjected to excessive heat, dust or mechanical vibration.
Allow for adequate ventilation around the equipment, making sure that its vents are not obstructed. To
prevent excessive heating of the equipment, avoid mounting it directly above power amplifiers or other
devices that radiate significant amounts of heat such as, radiators and heaters. Keep the equipment out
of direct sunlight. Where necessary use fan cooled racks.
• Make sure that the mains voltage and fuse rating information of the equipment will be visible after
installation.
• Do not use the equipment in the vicinity of electrical devices, such as computer monitors or mobile
phones, which may generate electrical noise.
Audio connections
To ensure the correct and reliable operation of your Square ONE Dynamics, only high quality balanced,
screened, twisted pair audio cable should be used.
XLR connector shells should be of metal construction so that they provide a screen when connected to the
console and should have Pin 1 connected to the cable screen.