C. Signaling
On the device, the following plates have been displayed:
Identification ( Fig. 1-1- Identification plate)
Instructions
Duties / Forbidding
Warnings
Hazards
Warning:
Always
observe safety instructions displayed on these plates. Any infringement of
these recommendations could lead the serious injuries or death to operators and exposed
persons. Always check that the plates are applied and readable. If not, please set new plates or
replace them.
D. General safety instructions
Respect of the safety instructions allows operators to work safely and efficiently.
Check the efficiency of all of the security device.
Immediately report any malfunction
to the
person responsible in order to make the necessary interventions.
It is forbidden to remove or modify any security or protection device. In case of infringement,
warranty would be immediately void and the company would be cleared of any responsibility.
Warning:
It is forbidden to remove or disconnect any security device of the machine.
Warning:
It is forbidden to use the machine if the security devices are not activated.
According to applicable standards against accidents, when on the platform, operators must:
- Wear a helmet
-
Wear and hook the security harness
to the ring in the bucket
-
The operator on the ground must also wear a helmet.
Also wear adapted protection clothes (non-skid security shoes, reflective vest…). Do not
wear any jewellery, open or pensile clothes like ties, scarves that could be hooked by moving
elements.
Always keep access devices like handles, guard rails or steps and work surfaces clear and
clean in order to minimize risks of slipping and stumbling.
Always use handles, guard rails or steps and do not lean on control devices and oil pipes.
Clean shoe soles before accessing the lift.
Before use, always check for the efficiency of the device which should always be kept clean and
in a perfect state of operation by following the maintenance program.
Numerous parts of the lift are made in a special steel with a high elasticity. Never solder on any
part of the machine without a written authorisation and instructions from KLUBB.
To Next Page
Loading...
