KNF Laboport N820 - Table of Contents

LABOPORT Pumps and Systems Content
Translation of original Operating Instructions, english, KNF 121211-121345 01/10 3
Content Page
1.
About this document 4
1.1. Using the Operating Instructions 4
1.2. Symbols and Markings 4
2. Use 5
2.1. Proper Use 5
2.2. Improper Use 5
3. Safety 6
4. System overview 8
5. Technical Data 10
5.1. Pumps 10
5.2. Electrical Supply Unit 17
5.3. Vacuum Controller 17
5.4. Vacuum Systems 18
6. Design and Function 19
6.1. Pump 19
6.2. Separator 20
6.3. High Performance Condenser 21
6.4. Vacuum Controller 22
7. Installation, mounting and
connection 23
7.1. Connect pump 23
7.2. Baseplate 24
7.3. Separator 24
7.4. High Performance Condenser 25
7.5. Electrical Supply Unit and
Vacuum Controller 25
7.6. Gas Ballast 28
7.7. Mounting of Systems 28
7.7.1. System SR 28
7.7.2. System SH 29
7.7.3. System SC 30
7.7.4. System SCC 31
7.7.5. Retrofitting from System SC to
System SCC 32
8. Operation 33
8.1. Pump 33
8.1.1. Preparing for Start-up 33
8.1.2. Starting 33
8.2. Switching Pump/System on and
off 35
8.3. Notices related to System
Operation 35
8.3.1. Separators 35
8.3.2. High Performance Condenser 35
8.3.3. Vacuum Controller 36
8.3.4. Gas Ballast 36
9. Servicing 37
9.1. Servicing Schedule 37
9.2. Cleaning 37
9.2.1. Flushing Pump 37
9.2.2. Cleaning Pump 37
9.2.3. Emptying and Cleaning the
Separator 37
9.2.4. Emptying and Cleaning the
Condenser 37
9.3. Changing Diaphragm and Valve
Plates/Sealings 38
10. Troubleshooting 42
10.1. Pump/System without Vacuum
Controller 42
10.2. System with one Vacuum
Controller 43
10.3. System with two Vacuum
Controllers 45
10.4. Fault cannot be rectified 45
11. Ordering Information 46
11.1. Pumps and Spare Parts 46
11.2. Accessories for Pump Systems 46
12. Decontamination Declaration 47