Kodak 2100 - 5 User Mode; Parameters; Entering the User Mode; Modifying Parameters

KODAK 2100 Intraoral X-Ray System User Guide (SM700)_Ed04 5–1
Chapter 5
USER MODE
This chapter describes the various settings that you can select for the different pre-set modes. The
user mode also allows you to validate specific local requirements for some countries.
Parameters
Table 5–1 Parameters Available through the User Mode
Entering the User Mode
To enter the user mode, follow these steps:
1. Switch ON the unit.
The self-test is enabled. While the self-test is in progress, the software information (for
example, F718 2.1) is displayed.
2. Once F718 2.1 is displayed, press shortly on from the control timer unit.
You access the menu, when "USER" is displayed. The display intermittently shows the first
parameter (P 01) and its setting (for example, "ON").
3. To switch from one parameter to the other, turn in any direction.
Modifying Parameters
To modify parameters, follow these steps:
1. Turn to select the parameter to modify.
2. Press on until "EDIT" is displayed and a beep is heard.
The parameter value starts blinking.
Number Parameters Choice
P 01 Digital receptor ON/OFF (needed for correct emitted dose display)
P 05 Tube seasoning procedure Switches from OFF to ON
P 06 Show mode
ON: Disables the X-ray emission
OFF (default value): Enables the X-ray emission
_
+
_
+
_
+
_
+