Annually
7–2 MAINTENANCE
• Then, the system test starts. After the test is completed (indicated by a short beep), the
firmware version and the total number of exposures (divided by 10) performed by the unit
since first installation are displayed.
• If the test fails, an error message is displayed.
IMPORTANT
If a check result is not satisfactory, stop using the equipment and
contact your representative.
Annually
We recommend that a general inspection of the unit be carried out by an authorized service
technician provided by your representative.
Cleaning and Disinfecting the KODAK 2100 Intraoral X-ray
System
IMPORTANT
You must first clean the system before disinfection.
To clean the system, follow these steps:
1 Clean the outside of the equipment with a damp paper towel or a soft cloth using an
alcohol-based, non-corrosive cleaner.
2 Wipe off surfaces with disinfectant.
CAUTION
•Liquids must not drip into the equipment.
•Do not spray cleaner or disinfectant directly on the equipment.
•Protect the equipment from contamination using barriers
available from dental distributors.
•Follow the manufacturer’s safety recommendations when using a
cleaner or a disinfectant.
To Next Page
Loading...
