9/2007 SM700_K2100_03_en 5-3
E20 to E24 Filament voltage error. Turn off the system and restart. If the
problem persists, call a qualified service
technician and discontinue using the
equipment.
E30 Problem with voltage to main power
supply or to chemical capacitor.
Turn off the system and restart. If the
problem persists, call a qualified service
technician and discontinue using the
equipment.
E40 to E46 System error (problems with the
microprocessor on the power board).
Turn off the system and restart. If the
problem persists, call a qualified service
technician and discontinue using the
equipment.
E50 to E54 Problems with the I2C bus (the
connection between the control panel
and the power board).
Turn off the system and restart. If the
problem persists, call a qualified service
technician and discontinue using the
equipment.
Table 10. Error messages
Error message Cause How to cancel
To Next Page
Loading...
