PLACING
SLIDE
TRAY
ON
PROJECTOR
Place the loaded slide tray
on
the projector
so
that the hole
in the center of the tray fits over the center post
on
the top
of the projector; then turn the tray slowly in a
clockwise
direction until the TRAY INDEX BAR is opposite the GATE INDEX
on
the projector.
The
tray will drop down into operating
position
on
the projector.
If
the tray does not drop easily
into place, check the alignment of the index hole and the
index notch
as
described under "Loading Slide Tray"
on
page 7.
PROJECTING
SLIDES
Turn
on
the projection lamp by sliding the POWER SWITCH to
LAMP.
Briefly push the SELECT BAR partway down to put
the
fi
rst
sl
ide in viewi
ng
position.
NOTE
: The tray will drop farther down
on
the
projector during the first change cycle.
ELEVATION
To center the projected image
on
the screen vertically,
elevate the
front
of the projector
by
turning
the ELEVATING
WHEEL.
To Next Page
Loading...
