Kodak CAROUSEL 760H - Kodak 760 H_0010

10
RANDOM SELECTION OF SLIDES IN TRAYS
To project a particular slide in a tray:
1. Press the SELECT BAR firmly and hold it down.
2. Rotate the tray until the number of the slide you want to
project is opposite the gate index on the projector.
3. Release the select bar; the desired slide will be pro·
jected immediately.
REMOVING SLIDE TRAY
1. With the projector turned on, press the select bar firmly
and hold
it down.
2. Rotate the tray until the tray index bar is opposite the
gate index.
3. Release the select bar and then lift off the tray.
SHOWING SINGLE SLIDES
1. With the projector turned on, insert a slide (correctly
oriented) into the projector gate. Push the slide down
into the gate
as far as it will go.
2. After viewing the slide, press the SELECT BAR to eject the
slide from the gate.
You can now insert another slide
into the gate. (Slides up
to Va inch thick can be pro·
jected
by this method.)
AFTER THE SHOW
1. Remove the tray; then slide the power switch to OFF.
2. Lower the front of the projector by turning the elevating
wheel. Retract the leveling foot.
3. Retract the lens by turning the focus knob counter·
clockwise.
4. Unplug the power and remote·control cords. Fold the
power cord
by placing the ends of the cord together
and folding
it in about 4·inch lengths. Fold the remote·
control cord in the same way. Place the cords into the
cord compartment
in the bottom of the projector.