Momentarily press the forward or reverse button to change
slides
in
the desired direction. The reverse button must
be
firmly
pressed.
FOCUS
Let the projector warm
up
for about 30 seconds.
Focus
for
maximum sharpness at the center of the screen image
by
rotating the FOCUS KNOB.
You
will
need to focus only
the
first
picture
if
all
slides are
in
the same type
of
mount.
Under special
conditions-for
example,
when
you
are
projecting slides
in
intermixed types of slide
mounts-you
may
need
to readjust the focus manually.
To
demonstrate extreme focus changes, place card·
board·mounted slides
in
the tray with every other slide
in
LEVELING
FOOT
backwards.
You
can
see
the action of the automatic focus
system
by
watching the movement of the focus knob or
by
watching the screen image.
NOTE:
A matte-surface (write-on) slide or a mount with-
out film
can
cause the focus motor to run continuously_
REMOTE
CONTROL
The remote control
has
both
FOR
(forward)
and
REV
(re-
verse) buttons for controlling the direction in which the
slide tray rotates. Momentarily press either the forward or
the reverse button to change slides in the desired direction_
The reverse
button
must
be
firmly
pressed.
I M
PO
RT
ANT
:
If
the reverse button is not pressed
firmly, the tray
may
rotate
in
a forward direction.
To Next Page
Loading...
