7
Chapter 1
Setting the Date and Time
Setting the Date & Time, First Time
The Date and Time have been reset message appears the first time you turn
on the camera or if the battery is removed for an extended time.
1 SET DATE & TIME is highlighted. Press the
OK button.
(Select Cancel to set the date and time at a
later time.)
The Date & Time screen appears.
2 Go to step 4 below, Setting the Date & Time,
Anytime.
Setting the Date & Time, Anytime
1 Turn on the camera. Press the Menu button.
2 Press to highlight Setup Menu, then
press the OK button.
3 Press to highlight Date & Time, then
press the OK button.
The date format is YYYY/MM/DD. The time
is displayed in a 24-hour format.
4 Press to adjust the date and time. Press to advance to the
next setting.
5 When finished, press the OK button.
6 Press the Menu button to exit the menu.
The setting remains until you change it.
NOTE: Depending on your computer operating system, Kodak EasyShare
software may let your computer update the camera clock when you
connect the camera. See the EasyShare software Help for details.
OK
Menu
OK
To Next Page
Loading...
Need help?
General
