65
Chapter 9
Connecting the Camera Dock 6000
After the Kodak EasyShare software is loaded (see page 57), connect the
camera dock to your computer and to a power outlet. You need:
m The USB cable included with your camera
m The 5-volt AC adapter included with the camera dock
IMPORTANT: Make sure your camera is NOT in the camera dock
when you are connecting to power and the computer.
1 Plug the labeled end of the USB cable
into the labeled USB port on your computer.
See your computer user’s guide for details.
2 Plug the other end of the USB cable into the
square USB connector on the back of the
camera dock.
3 Plug the AC adapter into the round power
connector on the back of the camera dock
and into a power outlet.
Your AC adapter may differ from the one
pictured or may have additional plugs.
Use the plug that accommodates your
type of power outlet.
CAUTION:
CAUTION:CAUTION:
CAUTION:
Use only the 5-volt AC adapter included with the camera
dock 6000. Other adapters may cause damage to your
camera, camera dock, or AC adapter.
Leave the camera dock connected so it’s always ready to transfer pictures and
videos.
To Next Page
Loading...
Need help?
General
