62
Chapter 9
Camera Communications
Problem Cause Solution
The computer
cannot
communicate with
the camera.
There is a problem with
the configuration of the
USB port on your
computer.
See the following file on the
KODAK Picture Software CD:
USB.html
Or, go to www.kodak.com
and click Service and
Support.
Camera power is off. Turn on the camera
(page 5).
Battery is not charged. Replace or recharge the
batteries (page 3).
Some Advanced Power
Management utilities on
laptops can turn off
ports to save battery life.
See the Power Management
section of your laptop user’s
guide to disable this feature.
USB cable is not
securely connected.
Connect cable to camera and
computer ports (page 49).
Software is not installed. Install the software
(page 45).
There are too many
applications running on
your computer.
Disconnect your camera
from the computer. Close all
software applications,
reconnect your camera and
try again.
The Battery Monitor or
similar software runs
constantly.
Close that software before
starting the KODAK Software.
To Next Page
Loading...
Need help?
General
