6
Chapter 1
Setting the Date and Time
Setting the Date & Time, First Time
The Date & Time have been reset message appears the first time you turn on
the camera or if the battery is removed for an extended time.
1 SET DATE & TIME is highlighted. Press the
OK button.
The Date & Time screen appears. The date
format is YYYY/MM/DD. The time is
displayed in a 24-hour format.
Or, select CANCEL to set the date and time at
a later time.
2 Press to adjust the date and time.
Press to advance to the next setting.
3 When finished, press the OK button.
4 Press the Menu button to exit the menu.
The setting remains until you change it.
NOTE: Depending on your computer operating system, Kodak EasyShare
software may allow your computer to automatically update the camera
clock when you connect the camera. See the Kodak EasyShare software
Help for details.
Setting the Date & Time, Anytime
1 Turn on the camera. Press the Menu button.
2 Press to highlight Setup, then press the OK button.
3 Press to highlight Date & Time, then press the OK button.
4 Go to Step 2 of Setting the Date & Time, First Time.
OK
,
To Next Page
Loading...
Need help?
General
