Chapter 2
Power
You can set your EasyShare AiO to enter Standby mode after a timeout of 1 to 60 minutes.
To change the power settings
1 On the main Home Center window, click Configure Settings to display the settings options.
2 Click AiO Printer.
3 On the General tab, select a timeout values from the Standby drop-down list.
4 Click OK or Apply.
Printer
To change printer settings
1 On the main Home Center window, click Configure Settings to display the settings options.
2 Click AiO Printer. The EasyShare AiO dialog opens with the General tab selected.
3 On the General tab, change the following options as desired.
Audio feedback: When checked, a beep generated when you press a button on the Control Panel.
Name: Your EasyShare AiO has a serial number that is used to construct name for Bluetooth printing.
The default name is Kodak5500+XXXX, where XXXX represents the last four digits if the AiO
printer's serial number. You can change this to a more user-friendly name by entering a new name in
the edit box.
Duplexer ink dry time: Indicates how long to wait before a sheet is flipped by the optional duplexer.
4 Click OK or Apply.
Fax Connections
After completing all steps in the Setup Poster, use the instructions in this section to connect the fax feature
of your Kodak EasyShare AiO.
DSL Line
If you have Digital Subscriber Line (DSL) service through your phone company, use the instructions in this
section to connect a DSL filter between the telephone wall jack and your Kodak EasyShare AiO. This filter
removes the digital signal that would block your EasyShare AiO from communicating properly with the
telephone line.
CAUTION
If you have a DSL line and do not connect the DSL filter, you will not be able to send and receive
faxes with your EasyShare AiO.
30 Kodak EasyShare 5500 AiO
To Next Page
Loading...
