Chapter 8
Printhead
The printhead dispenses the ink from the ink cartridges onto the paper. Printer maintenance involves:
Calibration
Clean the printhead
Calibration
The Kodak EasyShare AiO performs a calibration every time you install or replace a printhead. However,
you can run a calibration if you are seeing changes in the image quality. Calibration aligns the printheads
and performs a nozzle health check to enable high-quality prints.
To calibrate from computer
1 Load the main tray or photo tray with photo paper.
IMPORTANT: If you don't have any photo paper, you can use plain paper, but photo paper is highly
recommended for calibrations.
2 Start the AiO Home Center.
3 Click to open the Help panel.
4 Under General Links, click Maintenance.
5 Click Calibration to make a calibration print.
6 Follow the instructions on the calibration print to calibrate the printer.
To calibrate from control panel
1 Load the main tray or photo tray with photo paper.
IMPORTANT: If you don't have any photo paper, you can use plain paper, but photo paper is highly
recommended for calibrations.
2 Press Menu.
3 Press b until Calibrate Printer is selected.
4 Press OK. A new screen appears with Print Calibration Page selected.
5 Press Start and follow the instructions on the LCD screen to complete the calibration.
Clean Printhead
If you notice a degradation in the quality of prints, the printhead may need cleaning.
To clean printhead from computer
1 Start the AiO Home Center.
2 Click to open the Help panel.
3 Under General Links, click Maintenance.
4 Click Printhead Cleaning.
142 Kodak EasyShare 5500 AiO
To Next Page
Loading...
