7
Chapter 1
Setting the Clock
The Date & Time screen is automatically displayed the first time you turn on the
camera or if the battery is removed for an extended time. If this is the first time
the camera has been turned on, go to step 4.
To set the date and time after that:
1 In Capture or Review mode, press the Menu
button.
2 Highlight Setup Menu , then press the
Select button.
3 Highlight Date & Time , then press the
Select button.
The date format is YYYY/MM/DD in a
24-hour format.
4 Press to move through the fields.
Press to adjust the settings.
5 Press the Select button to accept the
changes.
6 Press the Menu button to turn off the menu.
The setting remains until you change it.
NOTE: Depending on your computer operating system, KODAK EASYSHARE
Software may allow your computer to automatically update the camera
clock when you connect the camera. See the KODAK EASYSHARE
Software Help for details.
Select
Menu
To Next Page
Loading...
Need help?
General
