39
Chapter 5
Turning Off Quickview
After you take a picture, Quickview displays it on the LCD for approximately 5
seconds (see page 15). To save battery power, turn off Quickview:
1 In Capture or Review mode, press the Menu button.
2 Highlight Setup , then press the Select button.
3 Highlight Quickview , then press the Select button.
4 Highlight Off, then press the Select button.
5 Press the Menu button to turn off the menu.
The picture is not automatically displayed on the LCD after you take it.
To see the picture, press the Review button.
This setting remains until you change it.
Turning On Liveview
The Liveview feature displays a live image on the LCD so you can frame your
picture in the LCD instead of the Viewfinder (see page 14). The default setting
is Off, which means that you must press the Select button to see the live image.
IMPORTANT: Liveview quickly depletes battery power; use it
sparingly.
Turn on Liveview:
1 In Capture or Review mode, press the Menu button.
2 Highlight Setup , then press the Select button.
3 Highlight Liveview , then press the Select button.
4 Highlight On, then press the Select button.
The live image is displayed whenever the camera is on. Liveview
automatically turns off after one minute to conserve battery power.
You can manually turn it back on by pressing the Select button.
5 Press the Menu button to turn off the menu.
This setting remains until you change it.
To Next Page
Loading...
Need help?
General
