Getting started
www.kodak.com/go/support
5
Cartridge:
See Handling and storing the cartridge on page 1.
IMPORTANT:
Remove the cartridge when the cartridge light glows red (see page 49).
The cartridge may lock if there is a paper error. Clear the paper error (see
page 41
) and make sure the paper light is off before you remove the
cartridge.
1
2
3
Cartridge light
Cartridge-release tab
Open the cartridge door.
Insert the cartridge into the
chamber until it clicks into
place
.
4
Close the cartridge door.
Rotate the cartridge spool
clockwise just enough
to remove
the ribbon slack.
IMPORTANT: Too many rotations
may reduce the number of prints
you can make.
To remove the cartridge, push
up on the Cartridge-release tab
then pull out the cartridge.
To load the cartridge:
To Next Page
Loading...
