Setting up your digital camera
www.kodak.com/go/support
9
Refreshing the Kodak Ni-MH rechargeable camera battery
IMPORTANT:
The battery refresh feature is intended for use with the Kodak Ni-MH
rechargeable digital camera battery KAA2HR only. Li-Ion batteries do not
require refreshing.
NOTE: If you are getting fewer than 20 pictures per charge, you may need to refresh the battery. The
refresh cycle completely discharges the battery, then fully charges it. See Extending battery life,
page 60.
1 Make sure the Ni-MH rechargeable battery is in the camera.
2 Place your EasyShare camera on the printer dock (page 7).
3 Press and hold the Print Layout button, , and the Red-eye Reduction button,
, on the printer dock at the same time until the Battery status light blinks
amber (approximately 5 seconds), then release the buttons.
To purchase a Kodak Ni-MH rechargeable digital camera battery for your digital
camera, visit www.kodak.com/go/accessories. See your camera user’s guide for
battery compatibility.
8 hours for
full refresh
Battery light glows
green when
charging
is complete
.
Battery status light
To Next Page
Loading...
Need help?
General