Troubleshooting
www.kodak.com/go/support
39
Nothing happens
when you try to
print (from a
Kodak card
reader)
NOTE: The Kodak EasyShare printer dock plus is compatible with the
Kodak 8-in-1 card reader and the Kodak 6-in-1 card reader (each
sold separately). Other Kodak USB card readers may work with the
printer dock plus; however, other manufacturers’ card readers are
not supported.
■ Check the USB connections from the card reader to the printer
dock (page 14).
■ Re-establish the connection: disconnect, then reconnect the
USB cable from the card reader to the printer dock.
■ Make sure a memory card is inserted and that there is at least
one picture on the memory card.
Nothing happens
when you try to
print (from a
PictBridge
compatible device)
■ Check the USB connections from the PictBridge compatible
device to the printer dock (page 15).
■ Re-establish the connection: disconnect, then reconnect the
USB cable from the PictBridge compatible device to the printer
dock.
■ Make sure there is at least one picture in the PictBridge
compatible device’s internal memory or memory card.
Nothing happens
when you try to
print (from the
computer)
■ Check the USB connections from the printer dock to the
computer (page 25).
■ The computer may be transferring pictures. Wait a few
seconds, then try to again.
■ Access the printer menu for your system. Remove check marks
next to Pause Printing and Offline, if checked.
■ Close unnecessary software applications. Disconnect then
reconnect the USB cable from the printer dock to the
computer (page 25).
■ Make sure Kodak EasyShare software is installed (page 22).
Install if necessary. If you choose Custom installation, make
sure to install the printer driver.
■ Uninstall, then reinstall Kodak EasyShare software (page 22).
■ Make sure your computer meets the minimum system
requirements (page 22). Upgrade your system if necessary
If... Try the following
To Next Page
Loading...
Need help?
General
