Appendix
www.kodak.com/go/support
53
Additional safety and maintenance tips
■ Always follow basic safety precautions. Refer to the “Important Safety
Instructions” sheet packed with your printer dock.
■ Do not allow chemicals, such as suntan lotion, to come into contact with
the painted surface of the printer dock.
■ If the printer dock has been subjected to inclement weather or you suspect
water has gotten inside the printer dock, turn off the printer dock and
remove the paper tray and color cartridge. Allow all components to air-dry
for at least 24 hours before using the printer dock again. If this does not
resolve the problem, contact customer support (see page 51).
■ Connect a tripod directly to the camera; do not connect a tripod to the
camera dock or printer dock.
■ Service agreements are available in some countries. Contact a dealer of
Kodak products for more information.
■ The printer dock and the AC power adapter contain a small amount of lead
in the circuit board. Disposal of this material may be regulated due to
environmental considerations.
Disposal of the color cartridge is not regulated and should not be subject
to state or local landfill, incineration, or recycling requirements.
For more disposal or recycling information, contact your local authorities.
In the US, visit the Electronics Industry Alliance Web site at www.eiae.org.
Upgrading your software and firmware
Download the latest versions of the software included on the Kodak EasyShare
software CD and the printer dock firmware (the software that runs on the
printer dock). Visit www.kodak.com/go/printerdockdownloads.
To Next Page
Loading...
