A-61550 February 2010 4-7
3. Slide the printer carrier into the desired print position. See the
section entitled, “Changing print positions” later in this chapter for
more information.
4. Reinstall and close the printer access door.
5. Run a print test. See the next section for procedures.
Running a print test You can only run a print test by using the Kodak Scan Validation Tool.
1. Place a blank sheet of paper in the input tray.
2. Ensure that the ink cartridge is properly installed.
3. Select Start>Programs>Kodak>Document Imaging>Scan
Validation Tool.
4. Select TWAIN for the Driver Type and the KODAK Scanner: i1410/
i1420/i1440. The Scan Validation Tool dialog box will be displayed.
To Next Page
Loading...
