A-61550 February 2010 5-3
Cleaning the rollers and
transport
1. Manually rotate and wipe the rollers with a roller cleaning pad.
2. Clean any dust or debris in the slots around the drive rollers.
3. Wipe the upper and lower transport areas with a roller cleaning pad.
4. Dry the transport area with a dry Staticide Wipe.
5. Push against the raised edge on the left side of the rear roller cover
and pull the cover up and out to remove it.
6. Remove any dust or debris under the rear drive roller cover.
7. Reinstall the rear drive roller cover.
To Next Page
Loading...
