2-2 A-61677 December 2013
3. Click Next when the Welcome screen is displayed.
4. Click I Agree after you have read and agreed with the terms of the
Software License Agreement. The installation will start and several
progress screens will be displayed.
5. Click Finish when the installation is complete.
6. Remove the Installation CD from the CD-ROM drive.
Installing the Kodak Driver
Software: Linux operating
systems
Linux drivers can be found on the Kodak website. Visit
www.kodakalaris.com/go/disupport to obtain the most recent Linux
drivers and installation procedures.
Install the driver software before connecting the scanner to your PC.
NOTES:
• Depending on the operating system you are installing on (Ubuntu,
Fedora, or SUSE) the following procedures may be slightly different.
• Kodak Scanner software requires QT3. Verify that your system has
these installed (e.g., Fedora: Applications>Add/Remove
Software).
• You must be a super user to install the software.
Installing the Kodak Driver
Software: Mac computers
Available by request.
Connecting the power cord
and USB cable
When the drivers have been installed, connect the power supply, power
cord and USB cable to the scanner. Refer to the illustration below for
making proper connections. Make sure the power outlet is located
within 1.52 metres (5 feet) of the scanner and is easily accessible.
1. Select the appropriate AC power cord from the supply of power
cords packed with your scanner.
2. Attach the power cord to the power supply.
NOTE: Be sure that the power cord is securely attached to the
power supply.
3. Plug the output power cord from the power supply into the power
port on the scanner.
To Next Page
Loading...
