2-4 A-61677 December 2013
Turning on the scanner • Momentarily press the toggle button on the back of the scanner to
turn the scanner on.
When you turn on the scanner, the LED/Start button on the front of the
scanner will flash as the scanner goes through a series of self tests.
Please wait while the operating system synchronizes the scanner with
the installed software.
When the installation process is complete and ready to scan, the LED/
Start button will stop flashing and stay green.
Turning the scanner off To turn the scanner off, press the toggle button for 1 second.
NOTE: The Power Off energy saver feature will also turn the scanner
off after an extended period of time after the scanner is in power
saver mode. The default is 60 minutes, however, you can
configure this period of time via your scanning application. Valid
values are 0-240 minutes.
To Next Page
Loading...
